Cutting Torch Tips.

   / Cutting Torch Tips. #1  

EdKing

Platinum Member
Joined
Jan 28, 2002
Messages
851
Location
South West Pa/Greene county
Tractor
Long/Landtrac360DTC
I got a question for all you weldors out there. I just got a good deal on some cutting tips for my Oxy/Propane torches. I got 4 each size 4/0 and 5/0 tips and was wondering what the cutting capicity is for these size tips. I searched quite a bit on the net and couldn't find any info.

Thanks in advance,
 
   / Cutting Torch Tips. #2  
Ed
It depends on what manufacture made your tips. Check out this <A target="_blank" HREF=http://www.arcsmith.com/ntt/default.htm>SITE</A> . Their catalog list the different manufactures and thickness each tip will cut.
 
   / Cutting Torch Tips.
  • Thread Starter
#3  
Thanks Ron, I have a Harris torch. They list the 4/0 as 1/4", but not the 5/0. I guess it is just a little thinner capicity.
 

Tractor & Equipment Auctions

2020 KUBOTA RTV X1100C UTV (A51406)
2020 KUBOTA RTV...
2022 CASE TV370B SKID STEER (A51242)
2022 CASE TV370B...
(INOP) VOLVO L110H WHEEL LOADER (A50459)
(INOP) VOLVO L110H...
2017 Bomag BW90 AD-5 Vibratory Articulating Tandem Smooth Drum Roller (A50322)
2017 Bomag BW90...
SDLG WHEEL LOADER FORKS MAST W/ 48" FORKS (A51242)
SDLG WHEEL LOADER...
2011 ORTEQ ENERGY SERVICES 40 MANIFOLD TRAILER (A50854)
2011 ORTEQ ENERGY...
 
Top