cub cadet tank pto change

[sandy13]

I need a pto without the key built in for a gt1-jd08 ogura pto. It has a 20hp honda engine on it. The problem is I have to use the key on shaft which holds the drive pulley on which is 2.75 inches long. I may have to remove drive pulley and shorten key to make room for pto key. I have not found a pto that is made without the key. Any body had this problem? This is for M48HN cub cadet tank with 20hp honda engine.

 

[tomplum]

Welcome to TBN. That is relatively standard procedure when replacing clutches. If I read you right, the long key from the drive pulley is interfering with the key on the PTO. I've had that on older Deere equipment. As long as the drive pulley key can't go anywhere, you're fine.