I have a cub 3235 I bought it new in 2001-02. It ran great until this summer. About half way through mowing my yard it lost all power. I took the hyd pump a part the gerotor was broke a small section chewed up. I replace the gerotor the internal filter. I clean the valves out the best I could. I put it back together no power to deck lift or trans. Little power to power steering. Is there air in the system and how do I bleed the air out? Is there still metal shavings in the system? Maybe the pump is shot. I appreciate any help. thanks jeff262
cub 3235 hyd pump no power
- Thread starter jeff262
- Start date
- Views: 2376
-
- Tags
- cub cadet 3235
Bob_Bainbridge
Platinum Member
Did you install the O-rings and seal correctly. Also check the relief valve to make sure metal particles aren't keeping it open.
Bob B.
Bob B.
JTKub
Veteran Member
Hmmm... dunno. The parts descriptions I've seen on the 2 or 3K series machines show a typical swash plate hydrostatic pump/drive. Didn't know there was a gearotor in there, unless that's the auxiliary pump for the steering and aux attachments.
Joel
Joel