imported_OWDouglas
Silver Member
Has anyone tried or purchased this? If so, I would like your opinion on it. Thinking about getting one, but would like to know if it works, or a scam.
Cool Tip Soldering Iron
- Thread starter imported_OWDouglas
- Start date
- Views: 1181
slowrev
Elite Member
They are only good for really small stuff. Notice what they are soldering in the commercial /forums/images/graemlins/smile.gif
I am also not sure if I would like to solder on electronics with them as they put current thru the item being soldered.
Ben
I am also not sure if I would like to solder on electronics with them as they put current thru the item being soldered.
Ben
ScottAR
Veteran Member
Garbage... A buddy had one melt down on it's trial run. Smallish speaker wire. The batteries got so hot they leaked acid afterward.
Those folks in the commericals must have numb fingers as the tip doesn't cool down as fast as they show.
No refunds on it, only replacments.
Those folks in the commericals must have numb fingers as the tip doesn't cool down as fast as they show.
No refunds on it, only replacments.
OP
imported_OWDouglas
Silver Member
Well that's all the input I need. I'll spend that 20 bucks eleswhere. (probably Harbor Freight) thanks everyone.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Ditto.. they are cr@p.
They can only solder like 18awg wire max.. and aren't any good on solder thicker than angle hair pasta. Besides.. like another poster says.. they run power thru 2 sides of the tip.. I'm not so sure how an ESD sensitive component might like the higher potential being generated on one of its legs.. etc.
Soundguy
They can only solder like 18awg wire max.. and aren't any good on solder thicker than angle hair pasta. Besides.. like another poster says.. they run power thru 2 sides of the tip.. I'm not so sure how an ESD sensitive component might like the higher potential being generated on one of its legs.. etc.
Soundguy
