Clutch - dunce question

[Ron25]

I have an Iseki 1910 that I have split to repair the clutch. I faced the flywheel, plate, had the finger tig'ed and milled and found a new disk. It has been over a month since I've taken it apart and can't recall which way the disk goes. There is basically a flat side and raised side. Which side goes to, say the flywheel?

 

[the bear]

the raised side goes to the realease bearing the flat side goes to the flywheel a little trick i do also is grease the realsease bearing if it doesnt have a grease nipple drill a small hole in back and fill it full of grease with a needle then use a small amount of silicone to fill the hole it seems that they never put enough grease in them don