clemsonfor
Super Member
I dont see a radiator on that one?
Check your Temp light
- Thread starter alorio1
- Start date
- Views: 5851
jerrybob
Super Member
Yea you're right.....I was focusing more on the mud.......that's what a lot of the yanmar tractors grew up in!
lewjay
New member
I bought a mechanical water temp gauge for my tractor. Had to buy the metric adaptor but while running the tractor in the Ga heat it did not get over 160.
Smoody
Platinum Member
Rule of thumb: When purchasing a yanmar or any tractor older then 10 years, put a new radiator in it and be done with it. I use to clean them but find it pointless and with the investment of a tractor whats a few hundred more to know the cooling system is ok. just my .02
clemsonfor
Super Member
good advice Smoody....long time no hear!!!
I haveent been on here much my self in the last year of so. trying to make it a point to get on here more recently.
I haveent been on here much my self in the last year of so. trying to make it a point to get on here more recently.
bmaverick
Super Member
- Joined
- Sep 17, 2013
- Messages
- 6,932
- Location
- Beloit-WI
- Tractor
- Yanmar YM2610 ■YANMAR GURU■ EXTRAORDINAIRE
Phew, this makes me glad I got my Yanmar from Fredricks Equipment. They rebuid the Yanmars here in the USA from the ground up. New RAD, hoses, clamps, etc. Nothing to worry about.
My idiot lights are not trustworthy at all. I'd like to put mechanical gauges on my 3110-D. Where can you find metric adapters for US oil pressure and temperature gauge sets? I'd appreciate any suggestions..... Just bought the gauges and looking...
I have a question, I hate the so called idiot light. Do they make a gauge kit for this application and if so, has anyone installed one and where did you put the gauge? What should the tempo be on these little rigs. Mine is a 2210BD. currently out of commission.
