Case Ih 995 spinning cover

[jwalsh]

I have a new to me case ih 995. I was working on my haybine last night and noticed this thing spinning next to the pto and I don’t think it should be. What is this part called and should it be spinning?

 

[jwalsh]

Here’s the pic with the part circled. I’m new to using a forum so it didn’t attach the first two times

 

[Farmer495]

I'd try that over at redpower, you have dual shaft set up, I run a 95 series but it's only single 540. Don't recall anything like that spinning.

 

[DLTrekkers]

The PTO sealcover next to it has a reses in it to stop that shaft from spinning.

 

[DLTrekkers]

It is a shaft with the idler gear between your topshaft and the bottom one.

 

[jwalsh]

The piece is flush with the rear end, should it be sticking out some in order to touch the pto cover or no?

 

[Farmer495]

The piece is flush with the rear end, should it be sticking out some in order to touch the pto cover or no?

I looked at my single shaft unit, the bottom cover on mine (no shaft) covers that straight line part.

You can see a straight line in the shaft you are talking about, does the cover around the bottom PTO shaft have a groove that would fit in?