case 4210 auxilary hydraulics failure

[robbb]

Hi recentley rebuilt a case 4210 and put new gears in gear box (3 gears gone bang oh dear ) haveing put cab back on and done a lot of spanner work etc everthing seems to work ok but I am haveing trouble getting auxilary hydraulics to work ,seems perhaps not enough oil kicking through . Levers seem to be operating valves ok any ideas gratefully recieved Rob.

 

[J_J]

Make yourself a hyd test set and take some pressure readings.

Check your pump to see if it is operating.

Remove a hyd hose and place in bucket and see if you have any flow.

 

[robbb]

Thanks , I will definately have to get a tester I think it will be very useful on our farm another member advised me to get one for another problem may speak to you again when I get time to do the job Rob.

 

[J_J]

Hydraulics:
Type: open center
Capacity: 9 gal [34.1 L] (2WD)
9.7 gal [36.7 L] (cab)
Pressure: 2500 psi [172.4 bar]
Valves: 0 to 3
Total flow: 16.1 gpm [60.9 lpm]
18.4 gpm [69.6 lpm] (optional)


TractorData.com CaseIH 4210 tractor information