dbdartman
Platinum Member
I'd start by trying to rotate the clip with a small/thin pin punch & hammer. If the bearing is against the clip holding it, you can also try driving the bearing back with a drift & hammer, against the inner race of course.
Can't get this keyway off...
- Thread starter stumpfield
- Start date
- Views: 17499
scott_vt
Super Member
- Joined
- Oct 5, 2004
- Messages
- 7,498
- Location
- east wells,vt
- Tractor
- 1986 MF 1040, 1942 Farmall A, 1949 Farmall Super A
Good Evenin Stump,
Was the key a woodruff key ? It looked like it might be in the picture !
I think Dbartman gave good advice on the snap ring, go slow and dont damage any parts unecessarily ! You will get it done, sounds like youve got the right mindset on this project !
Was the key a woodruff key ? It looked like it might be in the picture !
I think Dbartman gave good advice on the snap ring, go slow and dont damage any parts unecessarily ! You will get it done, sounds like youve got the right mindset on this project !
