JoeOtto
New member
I have had my new BX2350 for about 6 weeks. Two weekends ago I went and grabbed my new box blade to try and maintain my hilly, rainwashed driveway.
The tractor performed very well (as long as I didn't load the blade up with dirt and run out of traction going uphill).
When I started working at the end of the driveway by the road, I turned on the headlights and warning lights. (Wife called me a geek). A few minutes into the work, the warning lights are off.
A quick check revealed the fuse was blown. Replacing it resulted in immediately blowing the fuse when I turned the warning lights on. An obvious dead short somewhere.
I am guessing I pinched a wire somewhere, somehow, while using the blade, but I have looked and looked and looked and can find nothing.
I will call the dealer and have them find it if I can't. I wanted to see if anyone else has had this issue and where it could be shorted.
Ideas?
The tractor performed very well (as long as I didn't load the blade up with dirt and run out of traction going uphill).
When I started working at the end of the driveway by the road, I turned on the headlights and warning lights. (Wife called me a geek). A few minutes into the work, the warning lights are off.
A quick check revealed the fuse was blown. Replacing it resulted in immediately blowing the fuse when I turned the warning lights on. An obvious dead short somewhere.
I am guessing I pinched a wire somewhere, somehow, while using the blade, but I have looked and looked and looked and can find nothing.
I will call the dealer and have them find it if I can't. I wanted to see if anyone else has had this issue and where it could be shorted.
Ideas?
