BX22 rear axle issue - little power

SUPERNUG · Nov 6, 2009

My BX22 showed little power with the rear wheels today. Had to put it in 4 wheel to get anything done. Could this be a fluid issue as I noticed some fluid spots under the rear axle where it was parked? Any suggestions?

jnjpream · Nov 6, 2009

Have you checked the simple things? Fluid level, 3PT control in neutral, parking brake off, engine/fluid warmed up, hydraulic connections full seated, etc.. Have you taken off or put on an implement recently? Have you taken off or put on the loader recently?

Just searching for something that can help point out potential issues so we can help you out better.

Jeff

Raw Dodge · Nov 6, 2009

SUPERNUG said:
My BX22 showed little power with the rear wheels today. Had to put it in 4 wheel to get anything done. Could this be a fluid issue as I noticed some fluid spots under the rear axle where it was parked? Any suggestions?

If you have a hydro issue,putting in 4wd isnt going to do a thing! If putting it in 4wd helps,you were spinning a tire...

SUPERNUG · Nov 7, 2009

used it today and noticed a problem. The rear tires were loaded by the dealer when I bought it new. The reason I am losing power is the right rear rim spins inside the tire when more power is needed. What would cause this?

ultrarunner · Nov 7, 2009

Not enough friction between the bead and the rim... do you know what was used to load?

Sometimes, increasing the air pressure can help... they also make a bead sealer that is kind of sticky...

I foamed filled my tires and no more problems...

bp fick · Nov 7, 2009

Raw Dodge said:
,you were spinning a tire...

Good call!

redharley · Nov 7, 2009

Sounds like you need some air presure in there,some folks try to use all fliud and don't put any air in.You need soome presure in there to hold tire tight to rim