Nut on shaft from gear box that holds blade assembly,is it left handed or right handed. Older model 5 ft. Bushog brand. Need nut removed to remove stump jumper to get to gear box bolts to tighten or replace. Will not move either direction with 4ft. pipe on heavy socket wrench handle. 2" nut.
bushhog 5 ft.
- Thread starter fwill
- Start date
- Views: 973
rdbrumfield
Veteran Member
Yes, they can be tight. Mine turns to the left to remove. It is a Bushog 6ft, should be the same.
Glenn9643
Veteran Member
Yours may be different, but mine has a castle nut with cotterkey on a tapered shaft. It was a tough job to get off!
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Does your mower have a cutout hole in the deck to get at the blade nuts? If so. if you can get a wrench down on the bolt heads under the deck.. an air gun might spin the nuts tight for you.. or if they need replaced, just burn them out or cut the heads off with an angle grinder, and then install new bolts.. heads on the underside.. nuts on top.. air gun and wrench.. and go.
Soundguy
Soundguy
