bobcat s250 acs code32-39
- Thread starter fishcman
- Start date
- Views: 5608
-
- Tags
- bobcat s250
yellowdogsvc
Platinum Member
keep your hands off them when you start the machine. If one is not sitting in neutral, you will throw a code. Could be a bad controller.. maybe Doxie will weigh in on this.
mddorange
Elite Member
- Joined
- Jul 16, 2014
- Messages
- 3,357
- Location
- Guin, AL
- Tractor
- 2014 Kubota L3200 DT w/LA524 FEL, Loaded rear tires, LP RCR 1860 5' Cutter, LP RTA 1258 5' Tiller, LP PFL 2042 Pallet Forks w/60" Extensions, KK BB60 Box Blade, KK PHD-12" Post Hole Digger
:welcome:
To the forum from Alabama.
To the forum from Alabama.
SSdoxie
Elite Member
To list some things that can cause this:
1. Inadvertnally moving a control while reaching to push the PTO button.
2. Weak springs in control, not bringing it back clsoe to center.
3. Actuator getting worn, not returning to neutral or sensor in actuator worn and not sending correct feedback signal.
4. Control valve spool or the valve centering spring binding not allowing it to center.
Try starting without hands on the controls. If problem still happens, with key off jiggle the controls trying to feel for most neutral spot then re-try starting without touching controls.
If either of these don't work, the best bet is have a dealer hook up his laptop to read the system to see what is going on.
1. Inadvertnally moving a control while reaching to push the PTO button.
2. Weak springs in control, not bringing it back clsoe to center.
3. Actuator getting worn, not returning to neutral or sensor in actuator worn and not sending correct feedback signal.
4. Control valve spool or the valve centering spring binding not allowing it to center.
Try starting without hands on the controls. If problem still happens, with key off jiggle the controls trying to feel for most neutral spot then re-try starting without touching controls.
If either of these don't work, the best bet is have a dealer hook up his laptop to read the system to see what is going on.
manualengine
New member
32-39 ACS lift actuator is not in the neutral position
