Bobcat 335 excavator panel / controller

[Roughryder]

I first thought the key switch was bad. Sometimes it would light up the panel and sometimes not. When it did light up everything worked as it should. Now the panel doesn't light up except for perhaps the seat belt indicator. Even this is not consistent. Often just 1, 2, or 3 "idiot" lights will flash when the key is turned. The starter will always turn over but without the fuel solenoid receiving directions from the panel the engine will not start. I have checked grounds to the panel and I believe them to be good. Fuses all tested good. I jumper the key switch and still nothing.

So, any ideas ?

 

[Jabonee]

MX needs plugged in at dealer to check service codes. Check "switched power" relay. Possible bad MX display controller.:confused3: