Blown F1 fuse, NOT the CSA.

[jsasser]

On a 5625, while running, I came to a stop, put in neutral, brought engine to high rev to engage PTO, pulled PTO lever 1/2 way, and before the PTO got to max rpm, the tractor shuts down.

I instantly knew which fuse to check, the F1 key switch fuse. I’ve experienced this fuse blowing in the past. I’ve already replaced the CSA sensor, in fact when I discovered the fuse had blown, I unplugged the CSA and replaced the fuse just for it to blow again.

So, my question is, if it’s not the CSA, then what else could it be?

I’ll note, 10 minutes before this happened, tractor was running fine while bushhogging for about 15 mins.

Almost daily use tractor.

 

[beenthere]

Welcome to TBN

Tell us what "CSA" stands for in your post.

Related to this thread?

John Deere 5525 electrical problem

My cab 5525 will not turn over, when I turn the key none of the gauges or lights come on but when I turn the light switch on the dash on the head light and blinkers work but nothing when I use the key....why don't I have power going to the ignition?

www.tractorbynet.com

 

[jsasser]

Welcome to TBN

Tell us what "CSA" stands for in your post.

Related to this thread?

John Deere 5525 electrical problem

My cab 5525 will not turn over, when I turn the key none of the gauges or lights come on but when I turn the light switch on the dash on the head light and blinkers work but nothing when I use the key....why don't I have power going to the ignition?

www.tractorbynet.com

Cold Start Advance sensor = CSA. Thanks, I should’ve clarified that.