Belt routing

[Capt.Ron]

Well I picked up a G4200 a while back. The belt was gone and the bearings to the right spindle was shot. I replaced the bearings and got a new belt (from My local Kubota Dealer). Put it all together and the belt last 100 yards. I'm thinkin I may have put it on wrong but I couldn't figure out a better route.
Does anyone know of an online diagram for the belt and the correct belt size?

 

[ibnxe]

I'm not familuar with the tractor you have, so I may not be of much help. I've never heard of a belt failing so quickly. Was it shreaded or did it just snap?

Is it possible that you have a siezed accessory shaft (alternator etc.)? I've seen this cause a belt to burn in two. Other than that, is it possible that it was overtightened?

 

[Capt.Ron]

I'm not familuar with the tractor you have, so I may not be of much help. I've never heard of a belt failing so quickly. Was it shreaded or did it just snap?

Is it possible that you have a siezed accessory shaft (alternator etc.)? I've seen this cause a belt to burn in two. Other than that, is it possible that it was overtightened?

It was the deck belt. All of the shafts are turning as they should. Could have been overtightened.

 

[Capt.Ron]

So nobody here has a diagram of the belt layout for my RC44-G deck??

 

[dodge man]

You might have to go by a dealer an pick one up.

 

[profnohair]

Kubotabooks.com has a free manual for the mower decks in the mowers and catchers directory.

Profnohair