Been maintaining the old thing pretty well. 3Point started sticking in whatever position it was in ocassionaly. Joggling the control would get it moving again. Now it has Quit working all together. So far" Cleaned filters, opened the footbaall plate on the hydralic control valve to flush that point out. Normally you crank the engine over and it flushes obstructions out of control valve. Now there is no fluid coming out at all. Took test plug out of Hydralic Cylinder and no pressure at all. And old post on here says Dual Compensator Spool could be the problem. If it is clogged you get no fluid flow so no pressure. Where is that located on the 250? Been over the pump and lines and dont find anything that looks like it. The problem appears to be plugged valve or bad pump. Dont want to order new hydralic pump wait a month for it and be back to square 1 when I install a new pump. I will appreciate any advice, even if you say Junk It.
Belarus 250AS 3 point quit working
- Thread starter kyguy
- Start date
- Views: 677
-
- Tags
- belarus 250as