b7100

[JPRambo]

I am building a new attachment for my kubota B7100. what I need is the measurements for the loader arms and hydroulic rams at the loader bucket. I would measure mine but I am in florida and the tractor is in Georgia (650 miles) anyone have the ability to measure theirs for me??? THANKS in advance. Jaime

 

[94BULLITT]

You may have better luck if you ask in the Kubota forum.

 

[petes]

I have a B7100 with a loader. email me a drawing of what measurements you want and I'll put a tape on it.

 

[KubotaSam]

The B7100 was made for a lot of years. There are different loaders that could be installed on a B7100. You need to identify what make and model loader you have or any info you receive could be wrong for your loader.

 

[JPRambo]

will this help?

 

[numerobis]

i have a b7100 with the loader LA300B would you like to have the measures to make yourself one or is it too late?

 

[JPRambo]

definately not too late. I am not sure of the model of the loader. it is the one in the picture.

 

[Carl_NH]

JPRambo,

With the image you provided you can measure this yourself to get it close. With the B7100 basic dimensions

Wheelbase: 49.5 inches [125 cm]

Length: 78.75 inches [200 cm]

Width: 40 inches [101 cm]

Height: 45.5 inches [115 cm]

Ground clearance: 11.375 inches [28 cm] (transmission case)

Clearance (front axle): 9.5 inches [24 cm

You can use measuring tools in Adobe to get the basic dimensions. I would not build from this but it gets you pretty close if you measure a "known" value then measure your picture. I have added your PDF with some red lines to and you can do the same with PDF.

Really depends on what you want to do?

Carl

 

[JPRambo]

what i need is the measurments to put brackets on the root bucket i am making to attach it to the loader arms and the hydroulic rams and their spacing.

 

[JPRambo]

I was told some can't open the tractor1.pdf. here a new one