B2150 loose steering

   / B2150 loose steering #1  

kcarl

Member
Joined
Apr 7, 2004
Messages
28
Location
NC, NW Piedmont area
Tractor
B2150
While torn down to replace the axle housing on my 2150, I decided to work on the loose steering. I replaced the worn rubber bushing on the steering wheel shaft, but still have a lot of left to right play before the pitman arm moves. There is a large adjustment screw with a lock nut on the steering shaft, but I think that is a relief valve screw/spring/poppet, which I'm assuming I shouldn't mess with. Does anyone know if there is an adjustment screw to tighten things up?

Thanks,
Kcarl
 
   / B2150 loose steering #2  
If the nut and set screw are on the side of the steering gearbox that is where you make your adjustment. Loosen the locknut and turn the screw untill it botoms out and back it off 1/4 turn and retighten the locknut. This should put you close.
Bill
 
   / B2150 loose steering
  • Thread Starter
#3  
the diagram indicates the nut and screw adjust a relief valve, which is a section above the gearbox.

thanks,
kcarl
 

Tractor & Equipment Auctions

2016 FORD TRANSIT 250 VAN (A51406)
2016 FORD TRANSIT...
2012 MACK GU713 DUMP TRUCK (A51406)
2012 MACK GU713...
2006 GMC C7500 DUMP TRUCK (A51406)
2006 GMC C7500...
2014 CATERPILLAR 277D SKID STEER LOADER (A51222)
2014 CATERPILLAR...
2013 Toyota Prius Hatchback (A50324)
2013 Toyota Prius...
2014 Chevrolet Spark Passenger Car, VIN # KL8CC6S95EC448493 (A50324)
2014 Chevrolet...
 
Top