/pine
Super Star Member
- Joined
- Mar 4, 2009
- Messages
- 15,763
Hope someone can help...I'm in FL and my tractor is in GA...
I'm guessing there is not much difference in the basic design of standard 48" loader buckets for the B and BX series...? I have a model LA 301 loader with a standard 48" (B1614) bucket...
I need to know the deadrise angle of the end plate from the toe of the bucket (cutting edge) to the top.
If anyone with a similar bucket would be kind enough to post the measurments... if the foot of the bucket is sitting flat on level ground an easy way to figure the angle is to measure from a plumb line up from the toe and measure back to the top of the bucket...
TIA
I'm guessing there is not much difference in the basic design of standard 48" loader buckets for the B and BX series...? I have a model LA 301 loader with a standard 48" (B1614) bucket...
I need to know the deadrise angle of the end plate from the toe of the bucket (cutting edge) to the top.
If anyone with a similar bucket would be kind enough to post the measurments... if the foot of the bucket is sitting flat on level ground an easy way to figure the angle is to measure from a plumb line up from the toe and measure back to the top of the bucket...
TIA
