B 2910 Hydro oil level

/ B 2910 Hydro oil level #1  

dlabrie

Gold Member
Joined
Apr 5, 2002
Messages
441
Location
Campton, NH
Tractor
Kubota B2910
Hi, I just finished the 6th or 7th 300 hour service on my 2001 b2910.

The manual specifies 3.83 gallons of hydro oil after a filter and hydro oil change. The last time I did the 300 hour maintenance, I made a note that the dip stick registered over filling. So, this time I only put in 3 gallons and it still reads just above the fill line.
I drained the oil from the plugs at the bottom of the front and rear transmission case. I replaced both hydro filters and cleaned the transmission strainer.

Should I be worried that I put almost a gallon less oil in?


Also, how does anyone see the oil level on that yellow dipstick! I have to lay it on a paper towel to see where the oil is.
 
/ B 2910 Hydro oil level #2  
Burn it a little
 
/ B 2910 Hydro oil level #3  
Very likely when you drain it there is quite a bit left in that you cannot drain out. A little overfill is not going to hurt anything either. Also, you should run it around a little and get things fully operational after the fill and then top it off. There may be some difference after running it.
 

Marketplace Items

Atlas Copco Air Compressor & Air Dryer (A62613)
Atlas Copco Air...
2008 CATERPILLAR D4K XL CRAWLER DOZER (A64279)
2008 CATERPILLAR...
2-Row Peanut Inverter (Chain Drive, PTO, 3-Point Hitch) (A61307)
2-Row Peanut...
LILLISTON 4R ROLLING CULTIVATOR (A63291)
LILLISTON 4R...
DRAGON 500 BBL ACID TANK (A58214)
DRAGON 500 BBL...
ATTENTION PLEASE READ (A64119)
ATTENTION PLEASE...
 
Top