I removed the MMD to put on new blades. Now I am trying to reattach, and even with my old arthritic hands I managed to get the 2 side pins and the front bracket on but I cannot get the collar or coupler on the drive shaft back on the rear gear. I twisted and turned the bracket to even up with the hole, I pushed as hard as I could on the shaft housing where it rises towards the end. I cannot feel the click of the bearing coupler on the gear! What am I doing wrong?
Mowing ATTACHING PTO SHAFT BEARING COUPLER
- Thread starter cutter49
- Start date
- Views: 881
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 26,998
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Soak it down with P Blaster or Liquid Wrench and then install it. I remember back when I had a MMD on one of my previous Kubby's. Was always a PITA to remount.