I just bought a 3720 cab deere and plan on transfering my curtis power angle snow plow from my kubota b3200 (no cab)to my 3720, my question is getting to mount the power angle unit that is now attached to my 3200's roll bar to the inside of the 3720's cab. is there a simple solution, I don't see one, (going on a 300cx loader)
attaching curtis snow plow hydrolics to my 3720 cab
- Thread starter B3200
- Start date
- Views: 1600
kennyd
Advertiser
Do you mean the valve? Not sure what the "power angle unit" is...
If so, then a electric diverter setup is the best since the you can operate it electrically inside the cab, you dont want to mount a regular valve in the beautiful cab!
If so, then a electric diverter setup is the best since the you can operate it electrically inside the cab, you dont want to mount a regular valve in the beautiful cab!
kennyd
Advertiser
It really should be in the hydraulics forum, ask a mod to move it...
You could also use the 3rd SCV kit form John Deere and, the 3rd function kit for your loader. Clean factory install.