ATF pump in tank system...

[/pine]

I have salvaged (from a dumping flatbed) a pump w/valve built into its own tank...Direct Mount Pumps and a compatible cylinder...

This pump can be powered by PTO, or a gas or electric motor...I intend to make a dumping trailer so I will be using either gas or electric power of which I already have both options...there are pros and cons for both but that is not what this is about...

The thing about this system is...it uses ATF fluid (as per manufacturer)...I was thinking it might be handy to be able to use this pump for something other than just the dump trailer..i.e., a wood splitter...my dilemma is if I make a splitter to quick connect to the trailer system because of the fluid I can't connect it to my tractors remotes...

I suppose one option is having a second cylinder and hoses...one for the trailer system and one for the tractor to run the splitter...?

This pump only puts out 1.8 GPM so it is very limited to what it can be used for...anyone have any feedback or suggestions...I'm just looking to get the most out of what I have.

 

[J_J]

Do you have a lot of time on your hands, that you want real slow operation?

The pump below only needs 5 HP, and will put out as much as 11 GPH, and only cost $125. What is the pressure capability on the small pump?

https://www.surpluscenter.com/item.asp?UID=3516012517214269&item=9-7503-11&catname=hydraulic

 

[/pine]

I know it would be slow for a splitter...it always worked the dump bed well

below are the specs on the pump...

* GPM - 1.8 @ 1000 RPM
* Displacement/Revolution - 0.45 cubic inches
* Maximum Pressure - 3500 PSI
* RPM - 300 to 1000
* Maximum RPM - 1000 RPM
* Rotation - Bi-Rotational

This pump is built into the tank with the valve on top...

 

[dawzie]

You should be able to use your splitter oil in the new found pump set-up with no problems.

 

[IceStationZebra]

I agree with Dawze. Just try to get as much of the old ATF out first.

ISZ