Another satisfied Fitrite hydraulic customer

[Herkypilot]

I use my box blade for a good bit of dirt work and I always thought it was a hassle to have to adjust the side link on the 3pt to get the angle I wanted so I've been looking at a hydraulic side link to make chore a bit easier. I have a single rear remote already. After reading posts on this site about Top & Tilt, I Contacted Brian by e-mail at Fitrite and told him the model tractor I have and what I wanted. He didn't need any measurements as he was familiar with my tractor model. The hydraulic cylinder was well packed in Styrofoam sheeting and had very good fit and finish.

I took about 15 minutes to install, including moving the adjustable link over to the left side and cleaning things up a bit. It works great.:thumbsup:



You need to have about a month and a half of lead time if you are ordering. Must be a small operation.

 

[DT86]

Congratulations! Everyone that orders from them seems to be pleased. Based on that I too will be ordering a TnT set up from them when funds allow.
As for the lead time, I'm pretty sure he is a one man band.

 

[Willl]

TNT is one of my yet to do projects. I'm jealous.

Off topic but I've got to ask, what's up with the wheel/tire on the post ?

 

[MtnViewRanch]

Congratulations! Everyone that orders from them seems to be pleased. Based on that I too will be ordering a TnT set up from them when funds allow.
As for the lead time, I'm pretty sure he is a one man band.

Well, my wife and a couple of cats help out too.

 

[Herkypilot]

"Off topic but I've got to ask, what's up with the wheel/tire on the post ?"

That's an old wheel off a yard cart. I put it on that long bolt sticking out of the post just to make it more visible to me backing my tractor into the shed stall until I remember to cut it off with my saws-all.