Advice -+- X495 PTO clutch replacement ...
- Thread starter Navvet
- Start date
- Views: 2428
-
- Tags
- john deere x495
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,519
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
Procedure is outlined in the service tech manual.. do you have it?
OP
Navvet
Silver Member
- Joined
- Nov 25, 2017
- Messages
- 181
- Location
- NC
- Tractor
- Mahindra 4025 Bobcat S185 John Deere X495 John Deere 6x4 Gator
Yes I do have the manual. I used it several years ago to diagnose and replace a faulty seal ring (so much trouble for a little piece of plastic). At that time I noticed the clutch plates were worn as well as one of the little springs were missing. I put it all back together and kept my fingers crossed. It has worked well until this summer when I noticed the blades bogging down in heavy grass without any effect on the engine .....
So, i guess the first thing I need to do is new PTO clutch plates (and a new seal ring).
I can't think of anything else I should refurb while I have the rear end torn apart, Just thought I'd toss this out on the forum to see if anyone has any idea's about anything else I should look at .....
So, i guess the first thing I need to do is new PTO clutch plates (and a new seal ring).
I can't think of anything else I should refurb while I have the rear end torn apart, Just thought I'd toss this out on the forum to see if anyone has any idea's about anything else I should look at .....