dselsor
New member
My 861 ford dies when I give it gas to fast and when the governor kicks in. It idles fine
861 ford dies when governor kicks in u
- Thread starter dselsor
- Start date
- Views: 2435
jaxs
Elite Member
Would you like to reveal which type fuel it use's? How does it act if hooked to a load such as 2 bottom plow and throttle slowly increased? Sitting still,in neautral at fast idle then suddenly given 3/4tr throttle?
How long have you owned it? Did it run well then one day start this? Did you change anything/work on it just before this begain (especially anything with throttle linkage)?
How long have you owned it? Did it run well then one day start this? Did you change anything/work on it just before this begain (especially anything with throttle linkage)?
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
If it is a gas job and stumbles when you give it throttle, see if a little choke helps.. If yes, open the main needle a half a turn and re-check. Too lean on the main and they will stumble on acceleration.
If a diesel, your Roosa master pump may have a broken plastic governor ring..
If a diesel, your Roosa master pump may have a broken plastic governor ring..