7235 &7275 Motor breaking and excessive clutches

[JimR]

Thanks Cub, that will save me some time of calling Woods to see if they have the pictures. We'll all be waiting to see them.
Thanks,
Jim

 

[Outlander1]

I just posted a diagram of what is supposed to be the latest rear mount setup for the 417 Woods/Cub loader. P/N is there too. Looks like the earlier mounts were separate pieces..? The latest is one piece...? Might well be wrong about all of this...? Pic under Outlander1 I guess..? Never posted a pic before.......

 

[cubhater]

Outlander
Mine were installed about 1998 and are two pieces. They aren"t very big either. Just take some of the strain off where it is coupled together. The old Gunny

 

[cubhater]

My neighbor will be over tomorrow to take pictures of the brackets and post them. I am not smart enough to do it.

 

[JimR]

Thanks, I'm dying to see what they look like. I've been straight out trying to cure my ails with my black smoking Cub at WOT and restoring my latest pickup.

 

[cubhater]

Jim, here is the picture of the bracket

 

[JimR]

Hey Cub, Thanks for the picture. Where is this bracket located?

 

[cubhater]

Jim
From the rear of the frame to the loader brackets. Directly under the starter. There is also one on the other side of the frame. It is two pieces.

 

[JerryG]

It looks like it goes from the side of the bell housing to the side of the motor. Is that right?

 

[JimR]

Stiffener kit WM51916 cost is $70.54 and not in stock at my local dealer. My tractor was not updated with this kit.