icl
New member
Need help, 15 amp fuse blows when installed. The instrument panel will not work at all. Tractor will start and run. any help will be appreciated.
6500 15 amp blows instrument panel
- Thread starter icl
- Start date
- Views: 2925
Coyote machine
Super Member
- Joined
- May 4, 2009
- Messages
- 7,641
- Location
- Southern VT
- Tractor
- 22 SANY SY 50U, '10 Kioti DK 40se/hst KL-401 FEL, loaded tires, KB-2485 bhoe, Tuffline TB160 BB, Woods QA forks, MIE Hydraulic bhoe thumb & ripper tooth, Igland 4001 winch, & GR-20 Log Grapple. Woods BBX72" Brush Mower. Diamondplate aluminum canopy
Welcome to TBN.
Do you have mice; tractor stored outside or inside?
Can you easily remove the dash panel, and or fuse box housing or get access to the back of the panels to look for chewed/frayed wires?
How many hours on the machine?
Any prior electrical issues or wacky gauge activity recently?
Until you have determined problem's cause I would disconnect the batteries negative cable as a precaution when not in use.
Do you have mice; tractor stored outside or inside?
Can you easily remove the dash panel, and or fuse box housing or get access to the back of the panels to look for chewed/frayed wires?
How many hours on the machine?
Any prior electrical issues or wacky gauge activity recently?
Until you have determined problem's cause I would disconnect the batteries negative cable as a precaution when not in use.
Coyote machine
Super Member
- Joined
- May 4, 2009
- Messages
- 7,641
- Location
- Southern VT
- Tractor
- 22 SANY SY 50U, '10 Kioti DK 40se/hst KL-401 FEL, loaded tires, KB-2485 bhoe, Tuffline TB160 BB, Woods QA forks, MIE Hydraulic bhoe thumb & ripper tooth, Igland 4001 winch, & GR-20 Log Grapple. Woods BBX72" Brush Mower. Diamondplate aluminum canopy
Before you remove the dash check the back of the fuse panel first. Do you have a Mahindra service manual or dealer nearby?
You need to determine what controls your gauges, most likely a relay that's not working properly. Without a wiring diagram it will be difficult to determine the cause of why the fuse blows, unless something like chewed wires present as an obvious cause.
You need to determine what controls your gauges, most likely a relay that's not working properly. Without a wiring diagram it will be difficult to determine the cause of why the fuse blows, unless something like chewed wires present as an obvious cause.
Coyote machine
Super Member
- Joined
- May 4, 2009
- Messages
- 7,641
- Location
- Southern VT
- Tractor
- 22 SANY SY 50U, '10 Kioti DK 40se/hst KL-401 FEL, loaded tires, KB-2485 bhoe, Tuffline TB160 BB, Woods QA forks, MIE Hydraulic bhoe thumb & ripper tooth, Igland 4001 winch, & GR-20 Log Grapple. Woods BBX72" Brush Mower. Diamondplate aluminum canopy
Turn off caps. Dealer nearby? You need wiring diagram/service manual to solve this problem.