59 Ford 631 Spring at bottom of throttle lever...

   / 59 Ford 631 Spring at bottom of throttle lever... #1  

dos0711

Member
Joined
Jun 3, 2005
Messages
27
Location
Northeast,Florida
Tractor
1959 Ford Workmaster 631
What is the purpose of the spring, washers and cotter pin that I've circled in red? Mine are missing and wonder if I should replace them.

 
   / 59 Ford 631 Spring at bottom of throttle lever... #2  
It probably just keeps the linkage from "pivoting/flopping" around and much and keeps everything more snug with less play. Does the engine rpm seem pretty constant/governor work well?
 
   / 59 Ford 631 Spring at bottom of throttle lever...
  • Thread Starter
#3  
It probably just keeps the linkage from "pivoting/flopping" around and much and keeps everything more snug with less play. Does the engine rpm seem pretty constant/governor work well?

Yes the governor works fine. The comp spring is in place and it holds a speed.
 
   / 59 Ford 631 Spring at bottom of throttle lever... #4  
Maybe it reduces wear over the long term. I'd say that your machine has held up pretty well as is :)
 
   / 59 Ford 631 Spring at bottom of throttle lever...
  • Thread Starter
#5  
Soundguy what are your thoughts...?
 
   / 59 Ford 631 Spring at bottom of throttle lever... #6  
I always assumed that it was intended to keep the throttle shaft from riding up out of position. The spring would allow some axial movement which would prevent binding, as opposed to a cotter pin and washer.
 
   / 59 Ford 631 Spring at bottom of throttle lever... #7  
agreed.. it's securing it in place and keeping it where it should be.
 

Tractor & Equipment Auctions

2009 Ford F250 Super Duty (A50515)
2009 Ford F250...
2014 BMW 328i Sedan (A50324)
2014 BMW 328i...
2007 INTERNATIONAL 7400 DT466 SFA 4X4X CHASSIS TRK (A51406)
2007 INTERNATIONAL...
Case IH 2388 Combine (A50514)
Case IH 2388...
2011 Ford Ranger Pickup Truck (A50323)
2011 Ford Ranger...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
 
Top