mvanhaerents
Member
I just thought I would post some information if any of you out there get a fault code 11 and the tractor stops moving in either direction. If you unplug any of the following sensors (MFWD, flywheel, forward potentiometer, reverse potentiometer, TPS) and check the voltage from the orange to the black it should be 5.0 volts. All of my sensors were reading 2.5V. Unplug the MFWD and Flywheel sensors each separately and see if the voltage returns back to 5.0 volts. My flywheel sensor had gone bad, and must have been pulling current to ground and lowering all the sensor's voltages. Replacing the sensor fixed the fault code 11 (short,short,long,long) and the tractor moves once again!
