3pt hitch?

[rambler]

Years ago I bought this 3pt hitch from a vendor that advertised here.

The black part, supplied my own red part.

Is that vendor still around? It had a gold and black sticker on it if I recall, but don’t remember the name and sticker is long gone.

I’d like another.

I can’t weld as good as the vendor could….

Paul

 

[LouNY]

A 3 point drawbar stabilizer;

 

[eolesen]

Welded three point hitch receivers are available for around $50 on Amazon... I've got one and its fairly sturdy.

 

[ruffdog]

I have one of these...light but very strong. US made.

3-Point Receiver Hitch (Blue) | eBay

 

[CliffordK]

For towing around the property, I just put a ball into the crossbar, and no stabilizer. As long as the hitch is good, it doesn't seem to roll the ball out of the hitch. But, rather, it tows just fine. Slow speeds, etc.

2 5/16" in an enlarged center hole. 2" on opposite side, and a bit over towards the side so hopefully they don't interfere while turning.

 

[GreyhawkUSA30340]

A 3 point drawbar stabilizer;
View attachment 4111489

The manufacturer is extrememetalproducts.com (you can buy direct from their site)

 

[Tinhack]

The manufacturer is extrememetalproducts.com (you can buy direct from their site)

Keep in mind that it doesn't include the receiver hitch or the draw bar.

 

[WranglerX]

For towing around the property, I just put a ball into the crossbar, and no stabilizer. As long as the hitch is good, it doesn't seem to roll the ball out of the hitch. But, rather, it tows just fine. Slow speeds, etc.

2 5/16" in an enlarged center hole. 2" on opposite side, and a bit over towards the side so hopefully they don't interfere while turning.

Same here only I use a anti roll fixture that clamps on crossbar and goes to 3PH arm to keep it from rolling...

 

[JDW 1]

Thanks for the idea, fabbed one up this morning

 

[RayIN]

Man, you guys have money. I made one myself but it is twisted in the middle so I can use a 3/4" bolt in the drawbar instead of the rectangle slot.