370d beaver.

[Alfaro]

All new clutch pack with bearings/ bushings. Tractor back together, press clutch pedal,shifts into gear, tractor will not move, readjust clutch linkage, tractor wants to move but won't . Can not find adjustment on linkage to correct this. Fluids are good, hydraulics work well. I'm stumped???

 

[Alfaro]

Tractor can be pushed in neutral, locked when tranny in gear...like it should......wtf. Pressure plate wrong way.....looks like it can only go one way. Spline hub faces away from flywheel

 

[Alfaro]

Cannot push tractor in gear with clutch petal depressed , I'm depressed lol

 

[Alfaro]

Any chance folks that I have put the clutch boss in backwards? Tractor pressure plate is forced half on/off. Clutch can't stroke to release and holds the fingers slightly when reassembled. Opinions,comments suggestions welcomed.thanks

 

[Jptech]

See if this diagram helps. ----------------------- John :drink:

 

[Alfaro]

It does to a degree, not exactly my tractors internals but basically the same. Of course most of them would be. Comes down to me putting the tob bearing boss in backwards and/or torquing the lock down bolt to tight to the shaft and not allowing it to travel on the drive shaft. Your thoughts?

 

[Alfaro]

What exactly does the bolt on the boss do? There is no milled tract for it to travel in. Anyone have a photo of what the boss looks like on the satoh s370 beaver. That alone might be helpful. Thx