300 loader - what are these holes for?

[Flywheel]

The small hole is where the loder is bolted to the pallet for shipping and the grommet is a spacer to prevent scratching the loader paint during shipping.

I don't believe it!

They are not for shipping - there is an attachment that uses those holes that I don't know of yet!!!!


Oh well - I was hoping there was something that would make my life easier - but I guess it's not so bad as it is...

Thanks Grizz!

 

[Sprocket1]

Could they be holes to run hydraulic lines thru for a grapple?

 

[RoyJackson]

The small hole is where the loder is bolted to the pallet for shipping and the grommet is a spacer to prevent scratching the loader paint during shipping.

Mystery solved!

Thanks Grizz!

 

[Flywheel]

Could they be holes to run hydraulic lines thru for a grapple?

Naaa - see Griz'z post...plus - you'd be better off running the line down the side....

 

[Mech]

Thanks for the information. I was using the grommets as a finger hole when I was getting on and off. Everytime it fell out I was searching for it and putting it back. Now I know that I will take them out.

 

[Flywheel]

Thanks for the information. I was using the grommets as a finger hole when I was getting on and off. Everytime it fell out I was searching for it and putting it back. Now I know that I will take them out.

too funny..

 

[Dutch445]

Thanks for the information. I was using the grommets as a finger hole when I was getting on and off. Everytime it fell out I was searching for it and putting it back. Now I know that I will take them out.

imagine slipping off the tractor, on a wet day, and your
finger stuck in that hole.... OUCH!

 

[Nuru]

Thanks Grizz, I was just going to say, that looks like the same shipping holes on the 200 cx, I had. i actually saw that one being uncrated.