speigs4eva
New member
Looking for input and advice........
Quick backstory:
Bought an '04 Kubota M4900sudt (used) a few years back. The dealer that I bought it from put a Rhino 3110 loader on it. Instead of plumbing it properly, they hosed it into the aux valve (rear remote) in the back. This causes the aux valve to trip when the loader cylinders are maxed.
Problem:
I'm looking to add a second aux valve and plumb the loader control valve (LCV) properly. I've found the whole goods kit for the second aux valve, but not sure how to get power to the LCV so I don't have to use either aux valve set. The LCV has the three ports to/from pump and four going to the loader cylinders.
Any and all advice would be HUGELY appreciated since I can't get ANY help from dealers or service shops. Thanks in advance
Quick backstory:
Bought an '04 Kubota M4900sudt (used) a few years back. The dealer that I bought it from put a Rhino 3110 loader on it. Instead of plumbing it properly, they hosed it into the aux valve (rear remote) in the back. This causes the aux valve to trip when the loader cylinders are maxed.
Problem:
I'm looking to add a second aux valve and plumb the loader control valve (LCV) properly. I've found the whole goods kit for the second aux valve, but not sure how to get power to the LCV so I don't have to use either aux valve set. The LCV has the three ports to/from pump and four going to the loader cylinders.
Any and all advice would be HUGELY appreciated since I can't get ANY help from dealers or service shops. Thanks in advance
