2910 Cruise Control not working

[Phazer]

The cruise control on my 2910 stopped working again. It springs right back up when you push it forward. I'm assuming something has vibrated loose again, This happend a few months ago, and the dealer fixed it by tightening a plate underneath. I looked for an hour and could not find what he tightered. He's 2 hours away, so I hate to go there to find out something so simple. Do any of you have a 2910 service manual that would show what bolt I need to tighten?
Thanks
Jim Fulford

 

[ronjhall]

Jim: There are 2 pages on Cruise Control. Hope you can read my scans. The manual paper is thin and some of the back side scaned thru. Here is page 1.

 

[ronjhall]

Jim: this is page 2.

 

[Anonymous Poster]

Just a thought, hold the lever while taking your foot off the hydro pedal. You may not be allowing the latch to engage.

 

[Anonymous Poster]

Just a thought, hold the lever while taking your foot off the hydro pedal. You may not be allowing the latch to engage fully. Keep in mind it's not electronic it's mechanical.

 

[markcg2000]

Ron, I think you slipped up... the "2" file is exactly the same as the "1" file /w3tcompact/icons/crazy.gif

<font color=green>mark</font color=green>

 

[ronjhall]

Thanks again Mark: Here is the correct page.

 

[Phazer]

Ron,
This should be exactly what I need to fix this. Thanks SOOO much. I'll crawl under Yoda tomorrow and see if I can fix it!

JimF