john15nlt
Member
- Joined
- May 12, 2009
- Messages
- 46
- Location
- Bridgeport Texas
- Tractor
- Ford 2000 1969 gas / Ford 4000 1973 Disel
anyone have the engine service manual with the steps to get this in and out, its hung up I just do not know by what.
2810 fuel injection pump removal and install
- Thread starter john15nlt
- Start date
- Views: 5900
thepumpguysc
Elite Member
Did u go thru the front & remove the 3 bolts that are holding the drive to the gear.??
thepumpguysc
Elite Member
Sorry.. thought it was a Ford 2810..
There is a cut-out in the block that allows the rack pin to slide by.. if u don't get the pin to the cut-out, it wont come out..{hung up}
Does it have an electric shut off solenoid?? shuts off w/ the key?? Take the solenoid out 1st..
Why are u taking it out??
There is a cut-out in the block that allows the rack pin to slide by.. if u don't get the pin to the cut-out, it wont come out..{hung up}
Does it have an electric shut off solenoid?? shuts off w/ the key?? Take the solenoid out 1st..
Why are u taking it out??
