2" receiver and bucket mount

Hdoilcan · Jul 4, 2015

On my L3540 I had a 2" receiver in the center from HF. Inline eith the forks I had 5/16" hooks and a clevis hook mount. I also had the 5/16" hooks at the ends...... those I had put on just to use for any left over chain (as a tie off). I used a hook in the 2" receiver....... I never ended up using the other hooks etc....... it was that handy.
On my new tractor I will have the same set up even tho I onky used the center 2" receiver...... just in case I ever need them.

Hdoilcan · Jul 4, 2015

On my L3540 I had a 2" receiver in the center from HF. Inline eith the forks I had 5/16" hooks and a clevis hook mount. I also had the 5/16" hooks at the ends...... those I had put on just to use for any left over chain (as a tie off). I used a hook in the 2" receiver....... I never ended up using the other hooks etc....... it was that handy.
On my new tractor I will have the same set up even tho I onky used the center 2" receiver...... just in case I ever need them.

houser52 · Jul 4, 2015

Got the two hooks welded on earlier this morning. Primered and shot a little orange paint on everything to keep the rust down. Maybe I'll go back later and paint the whole bucket... or not.

While I was at it I used the receiver and hook to move the box blade to the shop and added a 3/8 hook to the back of it. I think I'm going to like my new FEL accessories.