MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 58,150
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
One of these is handy for odd situations like this...
12mm Female Square Drain Plug/ Pipe Plug Socket ?? TYM Front axle drain & Vent pugs
- Thread starter Rightsaidfred
- Start date
- Views: 4138
-
- Tags
- axle front axle pipe plug tym
Torvy
Super Member
Not a fan of important info in title unless it is repeated in the text. I typically skim the title.
LouNY
Super Star Member
- Joined
- Jul 4, 2015
- Messages
- 12,358
- Location
- Greenwich, NY
- Tractor
- Branson 8050, IH 574, Oliver 1550 Diesel Utility (traded in on Branson) NH 8160. Kioti CK2620SECH
For female plugs if I don't have the correct size I will get a piece of square key stock to use and either weld it into a socket or use the crescent wrench on the key stock.
Or get a set like this;
18PCS Oil Drain Pipe Plug Hexagon Square Socket Key Removal Tool Set 3/8'' Drive | eBay
Or get a set like this;
18PCS Oil Drain Pipe Plug Hexagon Square Socket Key Removal Tool Set 3/8'' Drive | eBay
K5lwq
Elite Member
- Joined
- Aug 6, 2017
- Messages
- 4,818
- Location
- Mineola, TX
- Tractor
- Kioti LK2554, Branson 4815C, Satoh Beaver, Speedex
I believe we have a male drain plug that identifies as female.
OP is looking for a female 12mm square socket to remove his male drain plug.
Most of us would use an open end 12mm wrench for this or a bigger Crescent. But he is not a fan of these options.
OP is looking for a female 12mm square socket to remove his male drain plug.
Most of us would use an open end 12mm wrench for this or a bigger Crescent. But he is not a fan of these options.
pmsmechanic
Elite Member
- Joined
- Dec 6, 2013
- Messages
- 4,225
- Location
- Southern Alberta, Canada
- Tractor
- 4410 and F-935 John Deere, MF 245
This is the situation where I would use an adjustable wrench. Just tighten the jaw up and keep your thumb on the thumb wheel so it doesn't loosen off while turning. The reasoning is that an adjustable wrench has wider jaws than a flat wrench and is less likely to round off the corners.
That being said I have also made my own female sockets. In your case I would with a chop saw cut a U shaped 12mm square slot in the side of a half inch thick piece of steel. You then weld a flat piece across the hole of the U and you have a 12 mm female socket once it's welded to a spare regular socket.
That being said I have also made my own female sockets. In your case I would with a chop saw cut a U shaped 12mm square slot in the side of a half inch thick piece of steel. You then weld a flat piece across the hole of the U and you have a 12 mm female socket once it's welded to a spare regular socket.
jigs_n_fixtures
Veteran Member
8-pt 1/2-inch socket will work fine
jigs_n_fixtures
Veteran Member
Those are all “male”. The plug has the 12-mm square male hex protruding, and he needs the female socket.
Oh, sorry, read that the other way. This is the set I got for my T494. The 7/16 or 1/2 worked fine.
