time

Time to chop some **** up.

My Mom has gotten a bad diagnosis recently. We have been trying to help create as many good memories as possible, for her and for our family. We built some wooden tulips before Easter and had a painting party and cooked a big breakfast with close family, it was a really good time. This time...

Saturday I went out to my newly acquired 34 completely raw undeveloped acres and attempted to do some brush hogging. I currently own a relatively newer Kioti CX2510HST 25 hp tractor/loader/backhoe. I have not used it for anything up until this point for doing anything other than some light...

No start on my L 3301. Last started a week or so ago at a job site....did get rained on which made me cringe since it's been a garage queen... Battery is good ...all fuses at left kick panel are good. Tractor will start jumping the starter solenoid... I'm leaning toward ignition switch, or...

I’ve sat on them and played around for a few minutes in the past but this was the first time actually doing work. I helped put in field tile yesterday for a friend, we know someone that does it for a living. I’ve done a lot of construction staking in the past so I spent most of the time...

Hello, We are going on almost one year and we still haven't got this tractor back to normal. I was ill for part of the year so it didn't get worked on very often. It is a 2014 LS XU5055 with 1168 hrs. It has been going into limp mode ever since it was new. It only di it occasionally at first but...

Looking at replacing 20 year old LT190 with a 48 inch deck with a 54 or 60 inch ZT. Looking at slightly used JD Z920M or Z930M. Currently takes right at 2 hours and 20 minutes to mow 3 acres (some parts smooth, some rough) with trees, berms, garden for obstacles. Have looked at some of the...

The battery on my 2018 M7060 seems to need replacing (slow to crank after a week or so). My first thought was just to pull it, take to a local battery shop and get a replacement (because I'll bet Kubota is very proud of theirs). If I pull it, the tractor would be without any power for a week...

Hey gang, I am a first-time tractor owner and I need some advice. I am the first owner of a 2022 New Holland workmaster 75 with front-end loader (no cab, just ROPS, and a canopy). This is the first tractor that I have been responsible for repairs and maintenance on and I ran into some trouble...

Hey all, Quick question — anyone here using any kind of automated feedlot software to help track feeding schedules or tractor use? We’ve got tractors doing the usual — feed runs, manure, bedding — and started logging some of it through a system to see where we were losing time or doubling up...

Hello, I'm totally new to this and I'm looking to purchase my first tractor. I have a 16acre hobby farm. The land is relatively flat with a pond. Plan to use the tractor to move pallets of feed, move round bail, clear brush and fallen trees, move/put in rock, etc. I also plan to use it to...

To start off, I'm in the dfw, Texas area. I'm looking to get my first 40-55hp tractor with a budget of up to 45k. I've looked into multiple tractors. Kubota would be nice, but don't have that kubota mula. I've narrowed it down to a ls345E, Tym 394, or, but it's more pricey, kioti Ns4710. I am...

ORDER HERE SAVE OVER $900 Deal Ends Soon...

I bought this sawmill March of last year. Got it reasonably set up but then got extremely busy on my 850 sqft. addition/reno of our house, so the mill went on the back burner. Well we are back in the house and while it is not done, it is almost there. TIME TO GET ON THE MILL!!! My goal is...

I was sitting in a deer blind in central TX this morning. Right as the deer feeder went off at 7am, about 30 wild turkeys, which must have been roosting nearby, came in like a flashmob hitting a California department store. They came in flying and running in one giant swarm and proceeded to...

Went to bed too early, got up too early. Feel like crap. Who's idea was this? This time change suks.

From the article: "Removing the old dam was no small job. According to Pete Barber, restoration ecologist for the Cowlitz Indian Tribe, removing 20,000 cubic yards of materials that made up the 425-foot-long, 55-foot-tall dam required planning and coordination. Barber said it was one of the...

Every year the pumpkin farmers in our valley hold a punkin chunkin festival. I’m always amazed at the elaborate air cannons and the amount of effort that people put into building these things. And the distance they can hurl a pumpkin. https://townofestancia.com/liselodging/Pumpkin-Chunkin

Last winter I asked about the loose throttle on my Bolens G174 installed on a generator in my garage, tight to the wall. Once I understood the situation I leaned over the mechanism and drizzled a quantity of white Thread-Lok down onto the friction mechanism. The messy repair has worked very...

I bought a 1990 Ford New Holland 27 HP tractor/mower model CM274 4 WD , it has 476 +/- hours. It sat for a long time before the guy i bought it from bought it then sold it to me. It has a 3 cylinder Shibaro (?) diesel engine. It starts fine, runs fine, but it is blowing out about 1 quart of oil...

FREE WOODSMAN PACKAGE AND FREE SHIPPING FOR A LIMITED TIME! ORDER YOURS HERE Meet the Ultimate Rack - Your Tractor's New Best Friend Crafted for durability and versatility, the Ultimate Rack is not just a tool carrier; it's a time and energy saver. Whether it's forestry, property maintenance...

.

Going to need to move the 3038e & realized the tires on the aluma car hauler were overdue for replacement. It's been sitting a few years since I've taken to leaving the 3038e at the acreage & the tires are 13-14 years old now. Pulled it down on the drive & propped it up on the rear legs & jack...

Long time no talk. My Subaru Robin EH90 (aka Generac GTH990-ish) engine swap in my 2006 PT425 is still going about 8 years later. But the Carlisle All Trail tires that I bought a number of years ago are coming apart. The tread knobs are barely worn down at all. But on two of the tires, cracks...

would like to know how to separate the tractor. Foton 504

will be looking for a new or used tractor in the 35 HP range- In no rush -do prices fall in the autumn or winter??- thks

Decided to become a member to share my experiences with my TYM t654 bought in 2017 now has over 1700 hours Mostly good,some bad I live in Georgia Farm mostly hay (square bales)

Was looking at a thread and decided to check my Alerts. I've alerts for Later today AND for tomorrow!! Better get ready!

Hi guys, after 44+ years my 25 HP rated Kubota L245DT is getting a little old, tired and gray just like me. After almost 75 orbits around that large flaming ball in the sky I'm looking to substantially step up in HP and creature comforts. My first question of many to come is in regards to a cab...

Years ago (Yup more than a couple) we purchased a new TC40D New Holland Boomer with FEL and backhoe. It’s been a good reliable ride, BUT it has reached an age where it’s very hard to come by parts. 2 seasons back while clearing a section of our land I was backing (think the cops call it “backing...

I bought a farm in Upstate NY, I have leased most of the acres to a nearby farmer, so I'm just looking to maintain the 5 acres around our house. The terrian is flat with some hills. I'm looking to use the tractor for mowing and plowing my driveway along with yardwork/ landscaping projects. The...

I think this looks interesting and got me thinking if PT would ever make an electric model Nesher Equipment I have no issues with Gasoline or Diesel but do admire the simplicity of an electric motor driving the current hydraulics.

We have several in my area that are permanent. We go all the time to these, but it is a must do when ever we hear about a new one. These tend to be pop up markets that don't do it every year. We always find something really great, like Lamb sausage sticks, other jerky's, cheeses, local...

Made a quick video, hopefully it is helpful to anyone considering a 3 point splitter. I picked this one up for $250. I added the "table" area at the back to keep logs from falling down. I added a control rod coming from the tractor hydraulic block to the area where you stand. This is a simple...