new holland tc18

I'm new to this forum and see there is a wealth of information available with tons of helpful people. I am posting here to hopefully get some help in providing me with some information to repair my New Holland TC18 tractor. I seem to be leaking fluid near the Hydrostatic Transmission Assembly...

After I took off the bucket loader, I tried using the 3pt. The 3pt went down but then wont go back up. It wont go up or down. It's full of fluid, steering works and it drives fine. Any help would be greatly appreciated! Thanks in advance.

I am looking to get a set of ag tires for my TC18 that currently has turf tires. The tire sizes I need are 9.5-16 for the rear and 6-12 for the front. Am I looking for 16"x8" rims for the rear and 12"X5" for the front? is there a certain offset that I need? i found the part numbers from New...

Looking for a price on this tractor and implements. Manual transmission, 4x4, 612 hours, turf tires, heated cab. Light gray frame so I think it's an earlier model from what I've read.

Both seem to be right size for my needs Both have FEL Ford 1520 a little more HP 2006 TC18 is at $8000 FEL 1700 Hours 1520 (Do not know year yet) $10,500 FEL 1200 hours These are the two in my area at moment, not really set on any one brand just no Kubotas or JD at moment

I'm in the market for a grapple for my TC18 and really like the 50" model from Everything Attachments. Problem is they offer it with skid steer attachment or, for an extra $100, mountings for specific Kubota FELs. I don't want the added weight or cost of the skid steer mount so am looking to buy...

Hello everyone, A friend of mine is retiring and heading south and has two tractors for sale. The first is a TC18 with NH front mount snowblower, midmount mower and SIMs cab (heat, fan, hard doors), 680 hours, manual trans, 4wd. He is asking 12K. Second is a TC24da with FEL, HST, front...

Hi everyone. This will be my first post. I have owned a few Farmall Cubs but decided to step up to something a little more user friendly for my 16 acre homestead. I have been looking around, and found a New Holland TC18, 2003, with Koyker 80 FEL. The machine is a hydrostat and has rear...

Can someone please tell me where I can get a cheap version of a Sevice Manual for a TC18. On the New Holland site it's over $200 and Ebay is about the same. Or are these my only choices? Thanks

Can someone tell me what loader a TC18 takes and if there are any Cabs out there that fit a New Holland TC18? Thanks

Was working fine then started smoking from behind instramnt panel...any ideas?...something electrical but what?

Hello, I was hoping to have someone explain where and how to test to see if glow plugs are working. I've been having a hard time starting tractor even when its in heated garage. I have to plug block heater in for 15 minutes before it will start. Any info would be great! thanks, Joe

Seeking advice &/or user manual 4 attaching-removing Frnt Loader& Backhoe on NH TC18 I purchased a used New Holland TC18 last year complete with a Front End Loader and Backhoe attachment, also a 3-pt hitch mower (brushhog like) and there were no user manuals included to direct me in attaching...

Any know if a Kubota GCK60-B Grass Catcher will fit on a New Holland TC-18 with a 914A 54 inch deck?

I have a 2003 NH TC18 (the one that should take a 7106 loader). I have the opportunity to buy a small, used loader and can make my own mounting brackets. However, I can't find a good picture of the TC18 with a 7106 (or Koyker 80, etc.) mounted on it to be sure I have the correct mounting points...

Does anyone know if it is possible to get down pressure on the 3 point arms on a nh tc18? If so how can it be done?

Need advice on New Holland TC18. I have 6 acres and want to know if a very low hour 1 yr old TC18, with 60" rear discharge is adequate. Also what is the worth of the tractor alone. The land is about 4 acres of lawn, some of it is rough. I would also like information on a loader and...

These weights (about 190 lbs.) keep the front end on the ground when using the 600 lb. Woods 5' 3 pt. finish mower, the Woods 4' rotary and the King Kutter rear scoop! JimBinMI

Here's a picture of the floodlight that I mounted on the Mighty TC18, does a great job for evening 3 pt. hookups and viewing when working! JimBinMI

Attempting to attach a photo taken with a 35mm autofocus camera and scanned into my computer. This photo, I believe was taken summer of '99, soon after getting the Mighty TC18 in June of '99. JimBinMI We boys and our toys!

I am considering buying either a NH TC 18 or Kubota BX2200. Both have front loaders and mid mower decks. The TC 18 appears to have more capacity on the loader and rear PTO than the BX2200 and both are essentially the same price. Both are from the same dealer and there is no strong recommendation...