mule

I'm just curious if anyone knows where I might be able to find an idler pulley/mule drive for a Mott D9 flail mower on a Farmall Super A.

Happened three times today. Engine slows down and limps...fuel gauge bars go to one bar and then engine dies. After waiting a minute or so, it fires back up and then after a few minutes it goes thought the same slow...limps...dies cycle. Battery is fully charged, lots of fuel. Seems to be...

Just purchased a 2024 Kawsaki pro fx ranch edition 1000. does anyone else own this model ?

I purchased a kawasaki mule a few days ago, I looked it over and have decided to do a rebuild of sorts. I can't do a stock restoration on anything, it's just not in me to do that, I have to do it my way! For reference, This is my 2000 JD LT133 it's on its third hood, y'all know how bad these...

Hello everyone, I'm Jim, this is my first post. I am restoring a 2004 kawasaki mule 550, and I want to add a linear actuator to make the box a dump bed, dose anyone know what the stroke length of the factory unit is. I have several here I can retro fit and not spend the $1,200 for an oem part...

It is a nice and clean Mule with about 330 hrs. Few years ago started to die during work, gas symptoms. I'd give it 20 minutes to cool down and it would run again for a few weeks, before randomly dying again. Checked fuel line going to carb: sometimes fuel pump would work, others not...

Does anyone out there use an alternative type of battery in their Mule? I have an ancient 2500 Mule (Series 620 - 2WD) with a flooded-cell battery #CB16CL-B. My farm is hilly and pastures are bumpy and the battery acid frequently spills onto the frame. As the acid gets lower the output...

I was out of town and my friend used my 2010 Kawasaki mule to pull a stuck zero turn out of the mud. It now has a loud clunking noise coming from somewhere and I'm not really seeing where. The clunk happens in every gear, as well as neutral and speeds up and slows down with the throttle. Any...

After owning 2 mighty mule 500 gate openers and having the last one also fail with a bad control board as did the first one, i decided to not buy their overpriced replacement boards. I removed all of the insides, with the exception of the working motor and screw shaft; then from Amazon, bought 2...

I have a 2016 Mule that won't start. It was just fine yesterday when I parked it in the shop. It turns over just fine, but won't start. I pulled one of the plug wires off and got a good spark when cranking. I pulled a fuel line off where it connects to the injectors and it pumped lots of...