mahindra 4035

l have a mahindra 4035 HST and don't know where to find the location of the hydraulic suction filter Can anyone help?

Hello, new to the forum, I have a 09 Mahindra 4035 shuttle shift that is getting very difficult to shift into forward and reverse. The cable is a long purple one and looks to be impossible to get to the end that attaches to the transmission without taking the floor board off the tractor. Has...

I had an earlier post were my tractor won’t start. Well it’s still not starting. I originally thought it was the solenoid. Obviously, it wasn’t. I could now get the solenoid off my original starter do, I just decided to get a new starter w/solenoid. After replacing the starter it still won’t...

I have replace the return line to the tank. Replaced the filter and filter/bleed pump housing. And it still run but do the same thing but it was still getting air in the system. After talking to the service manager at the local Mahindra dealer he told me to replace the line going from the filter...

Hey all, I need to change the spin on hydraulic filter on my Mahindra 4035, can someone please tell me roughly how much fluid I'm going to lose? I'm assuming about a filters worth plus a little more since it sits higher on the tractor. Thanks

I have a Mahindra 4035 that has been running perfectly, until today. I started it and idled for a few moments, put in gear and drove forward, put it in reverse and drove a few feet, put it back in forward and the motor died. It will no longer start. It turns over quite well and I have checked...

I have a friend that has a Mahindra 4035 tractor and is having some major issues without much dealer support. The issues are the following backfires and smokes at random times, glow plug light not working and water is getting into fuel sytem. The tractor also quits when you get on a incline...

After several false starts, wife and I are ready to start working on turning our retirement property into something more than just a weekend destination. The first task is to get 2-3 acres of what is now non-productive hay fields into better shape so that it can be used for various gardening...

Mahindra 4025 clutch not completely disengaging I have been lurking in the forum for quite a while and finally decided to register. This is my first post. I bought a used Mahindra 4025 2WD a while back. At this point is has about 450 hours on it. When I depress the clutch (dual clutch) and go...

The time has come to load my Mahindra 4035 with Backhoe on a trailer. Already know the weights and have a suitable tow vehicle. Right now my tractor is sitting 150 miles away from me and I forgot to do one thing before I left it this weekend - I did not measure it from backhoe bucket to loader...

Any thoughts about one of these good or bad? Any known issues/problems? A used one just hit the market here and I知 trying to get more info about it. Thanks for your time. 450

A friend of mine is moving and offering this package to me for $27,000 . This will be my first tractor I recently acquired 40 acres in Idaho. Just wanted to get some feedback on price, quality, and if I should buy it or not. Any advice or feedback his appreciated. * 2015 Mahindra MAD...

Ok guys I'm new at this so here it goes. I have a 2014 mehindra 4035 it was running great I parked it for the week and came back to it a week later to use it and it wouldn't start. It acts like the shuttle is engaged or some safety system is keeping it from starting. I can turn the key on and...

New guy here, I have a 2009 Mahindra 4035 gear. When I try to start my tractor my heating element does not turn on, no light on the dash, no nothing. I pulled out the owners manual and started looking at the electrical diagram to find the cause. The only thing on the tractor I could find with a...

Hello everyone, Ive posted on here before about leaks with my 4035. Since day one I have had issues with oil/hyd leaks. When the tractor sits for a few days I always notice new drops of oil under the tractor (3 different places!). The tractor has gone to the dealer probably 5+ times since I...

I have a Mahindra 4035 4WD PST 2014 202 hours. The only problem I have had is two Hydraulic hoses broken. Just a note the dealer sad that Hyd. Hoses only warranty foe two years not under the 5 year warranty. This may turn out to be a problem$$ if these factory hoses keep popping. Broken hoses...

Have any of you guys found other companies that sell filters for Mahindra tractors? Called a few local places and had no luck on aftermarket filters. Ended up going to the dealer(50mins away) to get the filter. I remember reading that the motor in my 4035 might be a Perkins clone of some...

Hello Everyone, this thread developed in the buying forums, but since then it has morphed into more of an owning/operating issue. I am moving my posts and updates to this section and will provide updates on this thread from now on. Below is a brief synopsis of what I have been dealing with for...

I need help removing the fuel tank to properly clean it. I've already drained the tank and removed the 2 mounting straps. Now how do I remove the tank. I'm really hoping that I do not need to remove the fender.

Well today my Mahindra 4035 PST caught on fire today. I have not had a chance to contact the dealer yet, and am trying to find some guidance on taking the next step. My tractor is a 2011 and has 372 hours on it. I recently have had a starter issue( this is the 2nd time I have had an issue with...

Hello, I just came back from meeting with a local Mahindra dealer. He has offered to sell me his last new 4035 HST for $29,000 with a 6' standard duty rotary cutter, pallet forks, brush guard, loaded rear wheels, sales tax, delivery, 3.99% interest for 84 months. What do y'all think? I feel...

My 4035 has never made any trouble starting until today, and I can't figure it out. I had started it, backed it out of the barn and shut it back off before it had fully warmed up. I went back an hour later to move it again, and it will crank but not fire up. It's up to 18* and I've started it in...

Yes this is another " what size cutter" thread lol. Ive searched high and low on this site to figure out what size cutter I should go with, but haven't found any good info to make me sway one way or the other. I posted in the Mahindra forum asking what the 4035 owners were using, but haven't had...

Hi, new to forum and looking to purchase my first tractor in the next week or so. I have looked at JD, Kubota, LS, Kioti, and Mahindra. Narrowed it down to Mahindra 4035 PST or Kioti DK40SE HST. Comparing the two machines, I really liked the feel of the Mahindra better and it just seemed to be a...

Hi guys, new to the forum. Title pretty much says it all. Not trying to start 20 page war, just want to make an informed purchase as this will be my first tractor. I'm purchasing a new tractor to be used on 28.5 acres that is has 12 yr old longleaf pines (not in rows) and native hardwoods with a...

Hey yall we through this together for a potential customer of ours I hope yall enjoy it, its a but crude but we did a one take quick video Mahindra 4035 Power Shuttle - YouTube

Mahindra has always prided itself on Hp at lower rpm, because of lower fuel consumption and less wear and tear on the engines. These two models, and others, rev at high rpm than their previous formats and higher than that of competitor brands. I'm concerned that this will diminish the longevity...

Any thoughts on the Mahindra tractors? Right now considering a JD 3320 or 3038e. The Mahindra 4010 and 4035 are very interesting.

My 4035 PST had an issue with the F/N/R shuttle lever where you'd have to lift and pull it slightly towards reverse in order to activate the neutral safety switch. It was getting annoying so I decided to dig into it and see if there was an adjustment on the shifter cable. I did find an...

Howdy. Over the weekend, I test drove a Mahindra 4035 HST and Kubota L4240 HST, both with a FEL. There is one dissimilarity that really sticks out; the 4035 weighs 1146 lbs. more than the 4240, though it makes four less HP. I realize that weight can be an advantage in certain applications...

This is my first time posting on this website so please forgive me if this question have already been asked. I just purchased the Mahindra 4035 with the 485 backhoe attachment. I've removed the backhoe (which was really easy) and wanted to attach my brush hog to the three point hitch. When I...

Does anyone know what size the PTO spline is on a 4035? My tractor is 150 miles away or I would go an measure it myself. Thanks! Martin

Okay. Here's the pics, 2 year old Mahindra, 130 hours: Looks good from a distance... And the close up shots... My thing is is there is absolutely NO rust one the loader arms, frame or bucket. I've read that someone else makes Mahindras loaders? If this tractor was bathed in...

So I bought a Mahindra 4035 with a FEl and mechanical shuttle. It had 125 hours on it and (so I was told) has always been stored inside. I bought this tractor sight unseen, and had it delivered to me. From a distance the tractor looks to be brand new. A few surface scratches but nothing to...

What is the largest tiller that you would run for a 4035 HST tractor? around 33 HP at the PTO. Would love to get a 72" - but seems pushing it alot! Thoughts?

So I had a used 2010 (I think) Mahindra 4035 4X4 FEL with 110 hours on it delivered yesterday. I never went to inspect the tractor in person so when I was looking at it this morning, I noticed there is no rear remote on it. From what I researched and read, I thought one was standard? I...

Hey all, Thought I would post a few pics of my Mahindra in action! This is one cool machine!!! Mahindra Rocks!

Trying to pick from the Kubota L4600 or the Mahindra 4035 (both 4x4 with FEL). I want to use 6 foot implements, bush hog, maintain a gravel road, spread dirt and keep up about 300 acres of hunting property. The L4600 has a bigger engine (46 HP) but the 4035 has stronger FEL and is heavier...

Well i recently purchased a 4035 w/fel, quick detach bucket, grillguard and rear remote O and I also had the rear tires filled with a beet juice derivitive. I was just wandering if there was anybody here that has owned one for awhile and has any input on problems or like dislikes etc. I haven't...

I was under the impression that I needed to change the oil and filer, transmission filter and oil after the first 50 hours of operation. My operator's manual states that the motor oil and filter should be changed after the first initial 100 hours of operation and then every 200 hours. It...

Folks, You can see from my previous posts that I'm leaining toward the purchase of a Grand L3940 and loader. But yesterday, I met a man who runs a feed operation that told me I'd be doing myself an injustice if I didn't consider the Mahindra 4035. He's been in the grain business for 30 years...

I have not had the chance to test drive either one of these machines. I hope that changes this weekend. I was quoted around $23,000 this weekend at a Mahindra dealer for the 4035 HST model with FEL. However, he didn't have one on the lot for me to try out. I have not gotten a quote for the...

Went to the Mahindra dealer Monday for a price quote on a new Mahindra 4035 and got a $23,000.00 price. Does this sound right to anyone? Got to sit and feel this thing and would really like to upgrade from my 28hp Massey. but this price seems alittle much. I was also told that the engine was a...

I have 35 acres of hilly ground. I plant about 4 acres in corn,and have the rest fenced in for pasture. I buy my hay,but may have an chance to make some of my own. I have an International 454,(with out a loader)I am going to keep. And a Landtrac 330 HST with a loader. The 330 has been a good...