kohler

I bought this yesterday. I don't have it at home yet. It's been sitting in that spot untouched for 26yrs. It's a propane unit. I didn't see an hour meter but will look. It says 24Volts DC, I'm hoping the generator works as the engine starter. The engine has a hand crank but no starter. Its old...

I've had Kohler engines in a few lawn mowers and snow equipment over the years and they've been about the best I've owned and parts when needed were usually pretty available. It appears Kohler engines has been bought out and the future of the Kohler small engines is questionable.

haven't posted in a long time, recently I had some issues & thought I'd share, over the past year or so I've noticed the Kohler command 25 would just shut off in the middle of working, jiggle a few wires & bam fires up and runs well. next day try to start & no go, jiggle some wires and off to...

My dilemma.Do I need a new engine or can t be salvaged? My rookie mistake --->Replaced a leaking gasket on carburetor ( engine worked fine before leak developed ) After reassembly , I could not turn engine over with recoil type starter. It acted seized or locked up. I opened both oil level...

I had my PowerTrac PT425 finally running again for a period, and then it broke again. Ended up finding cylinder head #2 exhaust valve seat had come loose and boogered up a couple of areas around the seat location. I started trying to find a replacement head online and having trouble (more on...

I have a ZG127s, that has the hiss of death. One cylinder has compression and the other hisses. I have read about the head gaskets blowing and suspect that this is the case. My questions are? Will the new gaskets fix it and last? Do I need to replace the engine? Why will Kohler not admit...

I have a bolens HT-23 with the horizontal twin Kohler K582 engine (23 HP) It's getting difficult to start at times. I'm concerned about the ignition coil arrangement, as it uses one coil to fire both cylinders with a "wasted spark" philosophy. Of course that means one cylinder spark plug...

My problem, have to use choke to start, even when it's hot. It cranks very slow only when choke is on. Cranks normal with choke off, but it won't start without the choke, it doesn't need choke to stay running.i have changed plugs, fuel pump, coils, cleaned out carburetor, adjusted valves...

I have a Kohler powered T7 which came from the factory with the propane fuel setup. I had a little problem with it freezing up yesterday and, since I don't understand anything about the propane components (regulator thingy, mixer thingy) I have decided to just make my life simpler and convert it...

hello I have a ch18 kohler that idles fine but when I try to rev it it hesitates. I have cleaned ever jet multiple times and same with the carb does anyone know what's wrong?. has a new electric fuel pump that pumps fine, fuel is new and clear too

Hi, does anyone know where I can find the mounting and shaft dimensions for an old Kohler K161T engine? I'm working on an old Troybilt hose tiller probably from the early 70's and the mounting dimensions would be a big help before I start tearing everything down. Any help is greatly appreciated!