frontier

Looking for a gearbox for a Frontier Dgm1072r. Old one has Woods stamped on side. Can anyone tell me if there is a Woods mower with the same gearbox?

Do you happen to know if this is correct? Are these Maschios made in China? I'm considering the Frontier FL1163S, which comes to about $5500 with the equine discount or a Nova Tractor BCRM175 fro $3300. My notes:

I noticed the manual said to measure the front of the cutter vs the rear to set the angle. But as far as cut height, are y’all measuring from the bottom of deck to the ground? It looks as if these blades are even with the bottom of the cutter. MAYBE 1/4” higher. Other cutters I’ve seen the...

Hello all. I bought a used Frontier RC2060 cutter for my tractor. It had some rust in the corners, so I disassembled it and repainted it, looks good now. When I had it apart I notice the back left corner was “kicked up” about a half inch. In other words when I set it on the floor it won’t sit...

I'm looking for comments and thoughts for the John Deere Frontier RB2284 Rear Blade. I have a 72" Land Pride and I'm thinking of going to a wider and heavier blade. This is much heavier than my current blade and I don't have rear hydraulics. Is this too heavy to adjust without hydraulics? My...

Parts lookup or diagram

Hello My frontier RC2060 brush cutter has started to feel a little odd, .. more than usual vibration and noise during operation and a tendency to sometimes shave dirt even when the cutter is not at the lowest position . On inspecting the cutter, 1. I can see a thin film of oil on the underside...