draft

I just reinstalled our Englander 17-VL, just in time for the cold snap to get here. 9' of Duravent DVL double wall inside and 4 feet of Duravent Class A chimney leaving the vaulted ceiling living space. I fear the stove might draft too well with the new double wall flue pipes, is that possible...

My BIL and I were talking over Thanksgiving about him replacing his wood stove. They have an A frame house with a too big wood stove and an 8" pipe. It goes up 3 sections then through ~6' of double wall stainless and then through the roof. So a new stove will be a 6" flue. What is normally done...

I am looking at a tractor for my son, this little New Holland is about the right size for a teenager and has enough safety features that I feel comfortable with him on it. It runs and drives, but after warmup it starts to blow white smoke out of the road draft tube in a bad way. It smells like...

Hello I am having a terrible time getting the front draft rod back in place. It came right off so what am I doing wrong that I can't get it back into the correct hole or the other side in the groove??

Anyone use draft control on M7060 or similar? I didn't find it did anything while moldboard plowing. Other draft control tractors I've plowed with the draft lever could be used to raise and lower the plow. I moved the lockout on the back by the top link as per the book. I tried both the...

Hey all, I was doing a little mowing and plowing with my DK50 and the draft control seemed to be a little jerky, when I checked it out I noticed that the 2 nuts at the draft cylinders were loose enough that the top link bracket can separate a hair from the cylinder and seems to be a bit loose...

Have TYM 554 and lift arms will not raise the brush cutter. Attempted to move the draft lever but it will not move. How do I free the lever up.

I recently purchased a 1997 Kubota M4700 The 3 point hitch has 2 levers. One for position and one for draft control. It seems that the position control does nothing. The only way for me to move the 3ph is with the draft control. Is this normal? I'm not familiar with using draft control, but...

I recently purchased a 3-point backhoe attachment to go with my 3930. I know 3-point backhoes get a lot of hate, and are generally inferior to sub-frame mounts. However, due to my particular situation, I feel like the 3-point mount is the best choice for me. I'm saying this cause I'd like to...