Early 2000 D40 seldom starts on the first, second, third, etc key turn. I’ve pulled the starter and grounded it to the frame and it throws and spins solid every time. My best guess is a rusty flywheel here in the southern humidity prevents the starter from spinning the flywheel and starting...
Hope this is an easy question for someone on here. I need to know if my Case IH 255 Mini tractor with Mitsubishi K3E motor has cylinder sleeves. My parts break down does not show any and none of the cylinder rebuild kits show for 255. they all say 234 and 235 tractors. Trying to rebuild...
I have a farmall 31 that had sat for awhile, after starting it would barely move and the peddle would shutter really bad and after 30 seconds it took off like normal. it then seemed to loose speed and would only move under low rms, now after sitting for a couple hours in the cold it wont move...
I have a Case IH JX95 that appears to be running fine until a put a blade in the ground. It running without fault for 100 or so yards then the engine revs slow until the engine stops. Turning of the engine cranks for awhile, then revs to the proper rpm for 100 or so yards for the revs to slow...
Hi,
I have a Case IH Farmall 60B tractor it’s about 13 months old, 220 hours and still covered by warranty.
It developed an engine noise and lost power when I went to up the revs to turn on the PTO.
The dealer has done a pressure test, and said there were bits of metal in the oil. They say it...
My Maxxum 140 Pro will not backup when I Shift the shuttle to R (reverse), it goes forward . It did this a few weeks ago, but it worked after setting over night. I let it set over night , but that did not work this time. Still will not backup, does anyone have solution. Thank Gary .
trying to fix my case 2290's hydraulic leak
ive identified the leak to the hose that runs from the hydraulic pump to the main controls in the cab, i cant for the life of me figure out how to remove the hose, it spins freely but doesnt unscrew, and its not a push pull release
refrence pictures...
Pre-COVID, I was going to buy a Kubota M5-111 but, COVID hit before it could be delivered and all they got were "chicken coop" tractors which wouldn't work for me. Supply chain shortages and general price gouging due to limited supply and huge demand seems to be subsiding so, I'm back in the...
I have a new to me case ih 995. I was working on my haybine last night and noticed this thing spinning next to the pto and I don’t think it should be. What is this part called and should it be spinning?
Hey everyone,
I have a 1988 Case IH 275 compact tractor with a 3 speed transmission, and a 3 speed range transmission. Everything on it works great, except it will randomly stop moving while going in forward or reverse. After about 2-3 minutes of the tractor running, it will just stop...
Hello all!
First of all i'm new member to the forum and with limited knowledge of tractors,
I'm helping out my family with some tractor issues.
Our IH 956 xl does not have any heater plug installed, it looks like the previous owner removed it and plugged the intake manifold.
I have searched...
I'm looking to buy an older Case Maxxum 125 for an all around ranch tractor. What are the pros and cons of common rail injection vs mechanical?
Is there any difference in fuel economy? Long term maintenance?
I'd appreciate any input.