brush

Bought a used Quick Attach 72" Brush Buster mower for the skid loader. Need to rebuild the hydraulic motor, but the Eaton sticker with the motor number is half destroyed. All that is legible is 104-5127-. If anyone has one of these mowers and wouldn't mind getting the number off the motor...

Considering buying one of these units,anyone have any experience with these.I believe they are made by Bradco/Paladin

EDIT: I finally bit the bullet and ordered a brush cutter. I decided to go with the ES Steel 36” model. I chose this one because of a few items, but honestly don’t know if some of the reasons are that big of a deal. Time will tell once I get it and give it a try. > 3 blades > bolt on side...

Seems as though I have a ton of weed tree saplings that are too small for the chainsaw but large enough to yank out so I ordered the 'Brush grubber.. Anyone use one? Do they hold up? Gonna use it behind one of my M9's on the drawbar to yank them out. Got the 'heavy duty' model. Is it heavy...

I have a DR Brushmower that runs at a slow idle when fully choked, dies when I move to run. It’s a 15hp Kawasaki engine. If I fiddle with the throttle at the carb, I can get it to run at speed. There seems to be some feedback that is shutting down the engine. Does anyone have a shop manual with...

G’day Tractor Forum, I've recently picked up a Toro Z287L with a seized FH680V engine and a bad deck. I've cleaned up the engine, honed the cylinders, and soaked the heads in ATF. I reckon it'll run fine with new gaskets and oil. The deck is a non-original 52-inch replacement, but it’s beyond...