block heater

Sorry if this has been beaten to death but how effective are the lower radiator hose passive flow heaters? I am wanting to install a block heater kit on my emax 22s but not sure if the inline lower radiator hose type allows enough heat into the engine since it isn't pump driven like the...

I was hoping to install an engine block heater on my MX6000 that is used for moving firewood and snowplowing. We've had a few nights when the morning temps are below freezing and the tractor started HARD on those mornings. My old L3560 had an engine block heater that made it a little easier to...

Massey wants 328.00 for one which just threads in!!

What is the best type

I've got a 2008 2910i with kukje A1400N3 engine. I'm looking for glow plug part # and suppliers and block heater recommendations.

My Ford 3550 3 Cyl diesel has what looks to be a factory block heater, but the plug is missing. Any idea where I can buy one?

I recently purchased a 3031 with 524 hours on it. Winter is coming and I want to install a block heater. It may start fine without one, but I believe that it is so much easier on the engine being warm when its real cold. I'm in Missouri about 45 miles NW of St. Louis. We sometimes get negative...

I'm having problems finding a soft plug to install the engine block heater in a New Holland Boomer 54D tractor.

Anyone here have a block heater installed on their tractor with the S4L2 Mitsubishi? Want to add one but can't find any specs on what size etc I will need. Any info appreciated! TIA

After researching a lot, I couldn't find any info on if a freeze plug heater would work/fit on a Ford 1110. Now that I have one installed, I figured I would make a post so others searching can find the info. Messisks has both CNH industries, part # 86590117 & 86590273, listed as potential...

Anyone know what oil plug thread size is on a 2007 DK40SE HST? Thinking of getting an oil heater that goes in the oil drain plug hole. Anyone have any experience with heating the engine this way. Have a magnet heater on the frame rail next to pan as the pan is non-ferrous and it isn't really...

Hi guys, The photos say it all, but I've got a brand new block heater with a snapped power cord (1989 John Deere 2155). Was hoping to just plug and play with a new cord but the side that attaches to the block has a rubber weld and appears to be part of the unit. Obviously I prefer not to...