bearing

I just had my left front wheel outer bearing fail. Heard an odd screechy tearing sound, looked under the hood, and then the axle and saw the leaking seal. Dropped the loader and skidded on the back wheels and bucket to the shop. Took some thinking and and some extra weight on the rotary mower...

Purchased this last night for mowing chores. This thing is a beast, heavy gauge steel everywhere, Dana rear end, plenty of torque ( just wait till I install the secondary transmission) strong enough hydraulics My l2501 is garbage compared to how this thing was built. One wheel is flopping I...

In 2005 I bought what the invoice said was a KT09-59 tiller, but in fact is a KT03-59. I have manual for KT09 but need KT 03. More specifically I need the part number for my KT03-59 as lower bearing has gone bad. I still would like KT03-59 manual which I guess dealer should have given with...

Hi I have a Belarus T40 tractor that I am installing a new clutch in. I am at a loss as to how to replace the release bearings for the PTO clutch and the Main clutch. Any help would be most appreciated

I have B-7800 that has play in the forward/reverse pedal. What I found was a worn bushing mounted lever mounted way inside on the transmission I think this looks like a problem. What it does is make the forward/reverse pedal have travel in the neutral position. The year is a 1993 HST B-7800. I...

I have a ditch Witch model j20. I'm trying to remove the shaft extender that leads from the large pulley through the rear firewall into the gearbox that powers the trencher. The bearing went out and I need to replace it. Does anyone have any experience removing this pulley? There's very limited...

I purchased a king Kutter (tractor supply "County line branded") and have had this PTO attachment for a few years. Facing the back of the mower deck, the right side mandrel bearings are shot and the mandrel is in need of repair. Is it better to just remove the mandrel and replace the bearings...

Short story: I pulled the hydraulic cylinder case off of the differential gear case. When I turned the hydraulic cylinder case upside down, a small 1/4" bearing ball fell out. Any idea where this might have come from? Long story: Bought my first tractor, a used B7300 with 114 hours, from a...

I bought this 185 lo boy as a project for the winter. It had broken belts from the engine fly wheel to the pto driving shaft. After replacing the belts and starting the engine, there is a terribly loud noise from that area. I think that the bearing in the assembly that adjusts belt tension is...

I decided to do this myself. I couldn't find any videos on it but I found it really wasn't that difficult. Here is the video I posted. If anyone has leaks or needs info on how to do it check out the video or ask here and I'll see if I can give some good info:

Hello, very new to dealing with wheel bearings. I just have a couple of questions about the old hay wagon hub pictured below. Does the grease seal separate from hub where I’ve drawn that red line? Also, the little inset in the casting you can see when looking inside the hub (there is another...